Posts: 507
Threads: 0
Joined: Jan 2000
Hello,
Wondering if anyone has tried to modify an Incra miter gauge to fit in the slot on a Hammer K3... and if so, how?
Thanks!
Posts: 11,668
Threads: 0
Joined: Dec 2006
(10-17-2017, 11:46 PM)Israel Wrote: Hello,
Wondering if anyone has tried to modify an Incra miter gauge to fit in the slot on a Hammer K3... and if so, how?
Thanks!
I haven't done it but IIRC Incra can/will make custom miter bars for different tablesaws that then will fit onto their standard miter gauge heads. You might want to shoot them an email with the Hammer's miter slot dimensions and see what they say.
Posts: 29,152
Threads: 1
Joined: Aug 2002
10-18-2017, 09:30 AM
(This post was last modified: 10-18-2017, 12:08 PM by JGrout.)
I doubt it would be too hard
Take the head off the miter bar on the incra then using the existing parts from the CC on the slider figure out how to fit them together
the only thing you really need is the locking nut that goes in the slider and the detent point. If it was me I would mock up a "BAR" out of wood to figure out the important locations then either use aluminum bar to fabricate one or take it to a machinist to make one from steel
Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future John F. Kennedy
Posts: 1,794
Threads: 0
Joined: Oct 1999
(10-18-2017, 08:15 AM)Lumber Yard® Wrote: I haven't done it but IIRC Incra can/will make custom miter bars for different tablesaws that then will fit onto their standard miter gauge heads. You might want to shoot them an email with the Hammer's miter slot dimensions and see what they say.
there is this:
http://benchmark.20m.com/tools/HammerB3/...stall.html
Posts: 7,015
Threads: 0
Joined: Aug 2004
Location: Perth, Australia
I think that this is what you are looking for:
http://benchmark.20m.com/tools/HammerB3/...stall.html
Regards from Perth
Derek
Posts: 507
Threads: 0
Joined: Jan 2000
(10-21-2017, 03:54 AM)Derek Cohen Wrote: I think that this is what you are looking for: http://benchmark.20m.com/tools/HammerB3/...stall.html
Regards from Perth
Derek
Thanks for forwarding the link--very helpful!!