Posts: 18,320
Threads: 0
Joined: Mar 2003
(12-16-2019, 08:23 PM)mongo Wrote: My favorite is the one from lienielsen. It is not inexpensive however it is very well made.
Before I got that I used a normal eclipse guide.
I take it it's really worth the 15x uplift in price?
After 20 some years, I think it's about time to replace my eclipse..
mike
I ain't a Communist, necessarily, but I've been in the red all my life
Posts: 5,257
Threads: 0
Joined: Dec 2005
Worth it to me... yes. Makes things faster easier and I am not fighting the tool the whole time to keep things square. I have little enough time in the shop to spend it fighting tools, and it because its easy I am more likely to sharpen as needed..... other people will disagree. Some people like to work wood some people like to work on tools. Neither is wrong(if its a hobby) just figure out where you fall on that spectrum.
Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
(12-22-2019, 04:41 PM)mstens Wrote: I take it it's really worth the 15x uplift in price?
After 20 some years, I think it's about time to replace my eclipse..
Note that the LN skew holders only work with LN skew angles. The LV skew attachment will take pretty much anything.
Thanks, Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard
Posts: 18,320
Threads: 0
Joined: Mar 2003
(12-22-2019, 08:50 PM)cputnam Wrote: Note that the LN skew holders only work with LN skew angles. The LV skew attachment will take pretty much anything.
The mk II? I wasn't a fan of the mk I when I tried it. I had issues getting it to clamp as securely, and the narrow wheel was a detriment for me (I like the narrow wheel on the eclipse for hitting the edges of irons).
Or, is there another I've not seen.. I haven't actually been shopping, I'd pretty much figured I'd just get another eclipse (or a clone really).
mike
I ain't a Communist, necessarily, but I've been in the red all my life
Posts: 4,027
Threads: 0
Joined: Nov 2010
12-22-2019, 09:53 PM
(This post was last modified: 12-22-2019, 09:54 PM by bandit571.)
Hmmm...well, here is what I have been using...
Old MK1 plate to set the bevel angle. Irwin Marples guide to hold a chisel or plane iron....
Narex 6mm Mortise chisel. Angle was set at 25 degrees. Honed to 2500 grit, then stropped. Actually sharpened 3 chisels last night...
As the ends were getting worn, and rounded... Now have a single bevel...
Honing guide does have a bit too much blue paint....intend to strip as much as I can, later....grip seems fine, right now.
Show me a picture, I'll build a project from that
Posts: 18,320
Threads: 0
Joined: Mar 2003
mike
I ain't a Communist, necessarily, but I've been in the red all my life
