SOLD FS: Drill Press Milling Attachment

[Rick_B]

ITEM HAS BEEN SOLD

This drill press accessory was manufactured by Waterborg (see ad below).  It fits a drill press with a 2-3/4" column and will accept tools with a 3/8 diameter shank - although a creative person could make a different tool holder if desired.  The collet that holds the tool holder has a 1/2" diameter with a JT33 female end for the drill press spinde.  Not much else I can say about it.
 
I have no idea what the value of this accessory may be so I'm asking $125 + shipping as a starting point but will consider any reasonable offers.  You can't insult me with an offer.  This should fit in a medium flat rate box.
 
Thanks for looking
Rick

   

   

   

   

   

[Eric Commarato]

That's pretty cool!  Sort of eliminates the side forces from the quill bearings...