Replacing capacitor on condenser unit?
#9
Specs on mine say 45 + 10 mfd, 440v.

All I can find available are 370/440v. Ok to use that? 

Mine is working now, I just want to have a spare on hand.
VH07V  
Reply
#10
I'd hold out for the correct/same one.
Steve

Mo.



I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24


 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply
#11
(08-15-2024, 12:56 PM)EightFingers Wrote: Specs on mine say 45 + 10 mfd, 440v.

All I can find available are 370/440v. Ok to use that? 

Mine is working now, I just want to have a spare on hand.

The one you found marked 370/440 means it can replace ether one rated at 370 or 440 .  If a capacitor is just marked 440 you cannot replace it with one marked 370.   They did this to prevent confusion but it is just as confusing.
 Roly
Reply
#12
The dual voltage rating of caps is foolish. The v number is it’s insulation rating. Anything rated equal or higher than the original is fine. The mfd number is it’s capacitance. For convenience sake, match the original and you’re good to go.
Blackhat

Bad experiences come from poor decisions. So do good stories. 


Reply
#13
One I have now:

   


Found on Amazon:
   
VH07V  
Reply
#14
That will be fine.
Blackhat

Bad experiences come from poor decisions. So do good stories. 


Reply
#15
Blackhat:

I appreciate your advice!
VH07V  
Reply
#16
I was going to link your specific cap, but there's too many to choose from.
https://www.supplyhouse.com/sh/control/s...%2C%20440v
Sign at N.E. Vocational School Cabinetmaking Shop 1976, "Free knowledge given daily... Bring your own container"
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.