12-10-2015, 09:27 PM
Or have I just missed it
http://www.amazon.com/gp/product/B017DR9...ools&sr=1-7
http://www.amazon.com/gp/product/B017DR9...ools&sr=1-7
|
Is this new
|
12-10-2015, 09:45 PM
The product's been around for a few years; of course, I don't know anyone who's used one...
Good judgement is the product of experience.
Experience is the product of poor judgement. 
12-11-2015, 06:44 AM
It's new to me, though of little interest. I'll bet that has to be registered fairly precisely to get the dowel holes to match.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
12-11-2015, 10:51 AM
fredhargis said: I would think so too. As to the question on Amazon anyhow, right below the description it says. "#1 New Release in Biscuit & Plate Joiners"
Worst thing they can do is cook ya and eat ya
 GW
12-11-2015, 11:03 AM
At first glance it could be mistaken for the MAFELL duo dowel, but for the Triton there is no video available, for the MAFELL it has quite a few. Looking at the vid you will see absence of the registration pins, and I doubt the Triton has the registration fence.
Now this could do some joinery. https://www.youtube.com/watch?v=VUI67MZUsCs Dictum sells the tool, and template for Just $1,043.59 + S&H from Germany 
Worst thing they can do is cook ya and eat ya
GW
12-11-2015, 12:42 PM
The diagram of the tool on tritons web page shows registration pins. There is so little info. The version shown on Amazon comes with two 8mm bits. It does not say if they are interchangeable with other sizes. One of the Amazon mkt. sellers is selling the uk version for about $125, that comes with 10mm bits. More info would be nice.
12-11-2015, 03:53 PM
mbw said: Its a cheap knock off.
Alaskan's for Global Warming
Eagle River AK
12-11-2015, 10:16 PM
Oh, maybe I was thinking of the freud version.
http://www.rockler.com/how-to/freud-tool...n-cutting/
Good judgement is the product of experience.
Experience is the product of poor judgement. |
|
|
Users browsing this thread: 2 Guest(s)