Need help from someone to draw up a plan

[Arlin Eastman]

for me to follow in me making a cabinet that will set on top of a rolling metal cabinet with 2" thick maple top.

I need it to be 72" long, 36" high and 12" deep.

I need to build it in two pieces and hook them together.  I made one in PowerPoint and can not get it up here.  it needs for the bottom 2" to be an open space so I can put my grinders with Oneway wolverine system so the long arms will go all the way to the back. 

I have three blocks underneath of 2" high x 4" wide on each end and one in the middle to get this space.

Can anyone help a fella out?

I can send the PowerPoint sheet to you via email.

The upper 24" will be cabinets with 4 doors and the bottom 8" will be drawers with the reminder of the height of 2" in the blocks.  I can make the support blocks wider then 4" just need space of 17" to get the arms under it.

Thanks

[Arlin Eastman]

I put it in a PDF doc and hope it loads

[attachment=16951]