01-15-2020, 11:21 AM
Am in the process of making a downdraft table and have a few questions. Table will be approx. 24"x 48". Am wondering about what size and spacing of holes, any suggestions?
Downdraft Table?
|
01-15-2020, 11:21 AM
Am in the process of making a downdraft table and have a few questions. Table will be approx. 24"x 48". Am wondering about what size and spacing of holes, any suggestions?
01-15-2020, 01:43 PM
(This post was last modified: 01-15-2020, 02:09 PM by brianwelch.)
I have seen, and used, 1/4" th. masonite pegboard for the surface...approx 3/16"-->1/4" diameter holes on 1" grid...
01-15-2020, 01:58 PM
(01-15-2020, 11:21 AM)Stamper Wrote: Am in the process of making a downdraft table and have a few questions. Table will be approx. 24"x 48". Am wondering about what size and spacing of holes, any suggestions? Based on the dimensions in the Grizzly T10699 - Downdraft Table Kit "Each panel measures 6-3/4" W x 16-1/2" L" and there are 4 holes within the 6-3/4 width I would guess the hole width is somewhere between 3/4 and 7/8 It looks like the edges on these panels are approximately half the width of the space between the holes. Doing the math it looks like the holes are 7/8 and the spaces are 13/16 but it could be vice versa. If it were me I'd just buy these panels and build the downdraft box around them.
"Well, my time of not taking you seriously is coming to a middle."
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.