Woodnet Forums › › Active › Woodworking v
Router bit for working plastic
Thread Modes
Router bit for working plastic
Coop28 Offline
Member
Posts: 440
Threads: 0
Joined: Dec 2000
#5
08-01-2015, 05:58 PM
Do I need special router bit to work with plexiglass or lexan?
Find
Reply
Routerman Offline
Member
Posts: 3,268
Threads: 0
Joined: Oct 1999
#6
08-01-2015, 07:00 PM
Carbide, either solid or brazed-on.
Spirals ok.
Do it everyday.
Pat Warner
Website Find
Reply
handi Offline
Honored Veteran
Posts: 13,485
Threads: 0
Joined: Oct 1999
#7
08-01-2015, 07:05 PM
I made my living in plastics years back. Onsrud makes VERY GOOD bits specifically for plastics. Their "O" flute straight bit is the best plastic bit on the market IMHO.

All that being said, if you are cutting one or two parts, any sharp clean bit will work well, if you will be doing a lot, but specialty bits.

Ralph
Ralph Bagnall
www.woodcademy.com
Watch Woodcademy TV free on our website.
Website Find
Reply
Mr Eddie Offline
Member
Posts: 1,543
Threads: 0
Joined: Oct 2003
Location: Columbus, Ohio
#8
08-02-2015, 12:43 AM
Pat,
Some day I'm going to get to west coast again, drop by your shop, and get some lessons. Always nice to see your work.

Lonnie
Find
Reply


Forum Jump:


Users browsing this thread: 3 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.