The new Mikiespace - 40X64X16 Pole Barn

[BloomingtonMike]

Apparently the line comes in a coiled roll, and you buy the tool to straighten it?
What material is the line made of?
That conduit bender looks familiar.

Yes, it comes in 100' coil. You can try and hand straighten it but it is annoying and I like it to look better than I was doing without the straightener. Some folks have made a straightener using test plugs from HD. Pretty sure maxline either bough out the guys idea or just hakced together their own.

This maxline is hdpe-pex-hdpe layered in construction. Had enough to do on the shed so I just got theirs and got to work putting it up.

They also sell a rigid pipe push to connect version But this is MUCH cheaper than that other solution.

The conduit bender is GB and came from HD
.

[closed for business]

what compressor you got in the works for all that air line?

i've a 120 gallon 10hp 3phase dewalt colored one that might be up your alley.

[BloomingtonMike]

I have an ingersol 80 and puma 60. What brand motor is on the dewalt?

[Phil Thien]

I know it has been a ton of work but you are doing a brilliant job.

[KLaz]

I'll buy your straightener when you're done with it.  Say 20% off new

[BloomingtonMike]

Phil Thank you buddy!! Means a lot coming from you. Sincerely.

Klaz bud, you can borrow it for free (with full and refundable deposit) if you want no problem. PM sent. Another friend locally wants to use it too. Might as well share the wealth - I already paid for it.

[BloomingtonMike]

Still blocks and fittings.

[closed for business]

Baldor 10hp 3 phase linky a roo

[BloomingtonMike]

Built an aftercooler for the north wall airline setup. It is 50' of 3/4" type M copper. Also built a slat-wall soldering protection shield to protect my walls while installing it..

[BloomingtonMike]