Woodnet Forums › › Active › Woodworking Power Tools v
Delta Junior
Thread Modes
Delta Junior
tablesawtom Offline
Honored Veteran
Posts: 4,266
Threads: 0
Joined: Feb 2001
#8
11-18-2021, 01:47 PM
Is a Delta Junior a 8 inch table saw or a 9 inch? 

Tom
http://www.tablesawtom.com
Website Find
Reply
fredhargis Offline
Member
Posts: 12,605
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
#9
11-18-2021, 03:05 PM
Going from memory, it's an 8" saw.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Find
Reply
tablesawtom Offline
Honored Veteran
Posts: 4,266
Threads: 0
Joined: Feb 2001
#10
11-18-2021, 07:13 PM
(11-18-2021, 03:05 PM)fredhargis Wrote: Going from memory, it's an 8" saw.

I am thinking the same thing but just wanted to check, man the motor is something else on it.

Tom
http://www.tablesawtom.com
Website Find
Reply
med-one Offline
Member
Posts: 2,827
Threads: 2
Joined: Nov 2003
Location: S.E. Michigan
#11
11-19-2021, 10:34 AM
It takes a 8" blade for sure.
Find
Reply
Tony Z Offline
Something other--as requested
Posts: 12,299
Threads: 0
Joined: Mar 2006
#12
11-19-2021, 11:16 AM
Is that the Delta machine that had the motor hanging off the back, with the shaft going through, able to run a jointer or drill press also?
Waiting to grow up beyond being just a member
www.metaltech-pm.com
Website Find
Reply
tablesawtom Offline
Honored Veteran
Posts: 4,266
Threads: 0
Joined: Feb 2001
#13
11-20-2021, 10:05 AM
(11-19-2021, 11:16 AM)Tony Z Wrote: Is that the Delta machine that had the motor hanging off the back, with the shaft going through, able to run a jointer or drill press also?

No, it looks like an undersized UNI saw. I am tiring to decide to restore it or to part it out.

Tom
http://www.tablesawtom.com
Website Find
Reply
Tony Z Offline
Something other--as requested
Posts: 12,299
Threads: 0
Joined: Mar 2006
#14
11-20-2021, 02:26 PM
(11-20-2021, 10:05 AM)tablesawtom Wrote: No, it looks like an undersized UNI saw. I am tiring to decide to restore it or to part it out.

Tom

Thanks Tom. I have one of the types I described (I think I have it!), loaned to my brother in 1996. I have not seen it since. Tablesaw was just OK, but the 4” jointer was sweet!
Waiting to grow up beyond being just a member
www.metaltech-pm.com
Website Find
Reply


Forum Jump:


Users browsing this thread: 3 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.