New Jig for the Bench

[AgGEM]

Well worth the time to make these tail & head stocks. Even with the long center, it is quite ridged and aggressive sanding is no problem.
I expect applying the finish to the work will be a joy.
Ag

[Rob Young]

Yes, but would it work for a right-handed person?

Nifty setup.

[bennybmn]

I see you're using a holdfast, but I assume it registers in dog holes too? Looks super handy! I like the work light holding feature too

[AgGEM]

Yes, there are 2 pins in the dog holes. It needs both the pins and hold fasts to work.
I have a slotted screw and knob on the movable end. I might drill another dog hole to make it even stronger.
If you look closely at the bottom photo, you can see a gap between the bench top and the plywood on the movable stock. A hold fast there would help.

I painted the table last night, it was so easy to get around all of the surfaces.
Ag