▼ 
03-12-2016, 11:25 PM
Considering building one or two. Thinking bandsaw blades. Yes/no? Can a wood framed saw tension a 1/2" bandsaw blade enough?
Blackhat
Bad experiences come from poor decisions. So do good stories. ▼ 
03-13-2016, 02:30 AM
Old time frame saws for joinery often had blades around 40mm or 1 1/2 inch wide.
Though I think a bandsaw blade will be unsuitable for other reasons. The tooth pattern isn't suitable in my oppinion and hardened teeth cannot be filed. Some bandsaw blades also seem to be in the thick side.
Part timer living on the western coast of Finland. Not a native speaker of English
03-13-2016, 08:39 AM
You are better off buying some frame saw blades, and designing your build to fit them. Highland link shows some at 700mm for ECE saws, which is about 27 inches give or take. You can get a xcut and a rip for less than $20, well worth it. And these can be resharpened.
http://www.highlandwoodworking.com/bow-s...lades.aspx
Credo Elvem ipsum etiam vivere
Non impediti ratione cogitationis |
|
Frame saw folks
|
|
|
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
