5 Cut Method

[RJT123]

I put a new sacrificial fence on my Incra Express/1000SE sled. Gave me a chance to try the 5 cut method to align it to the blade. Followed this guys link:
http://valleywoodworkers.org/wp-content/...Square.pdf
Very nice, feeler guages, who knew? Sled is now way more square than is necessary for wood.
Just truing up all my machines for making new kitchen cabs.

[mikefm101]

I used this method last weekend for a small crosscut sled. Some test cuts were .0002" error ratio.

Making a new large sled soon and will use the same procedure.

Mike

[Steve N]

the William being referenced is William Ng. He shows the 5 cut along the way to building a very accurate sled in this video.

https://www.youtube.com/watch?v=UbG-n--LFgQ

Though I believe the 5 cut was around before William was a zygote