Posts: 5,845
Threads: 0
Joined: Apr 2003
I've never finished a rolling pin but if you're rolling out the typical doughs with flour, I wouldn't think you'd need anything except a really high grit finish with sandpaper. I wouldn't be afraid to go up to 600+.
If you need an oil finish, I'd splurge the $1 at Wally World for a bottle of mineral oil. A very thin coat of thinned down shellac would probably be just fine too. I wouldn't want any build on it though.
Posts: 22,035
Threads: 0
Joined: Oct 2003
Mahoney's or Butcher Block.
Don't use Olive oil--it can turn rancid.
Gary
Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.
Posts: 20,950
Threads: 0
Joined: May 2005
Naked is best, if you can stand to leave it that way. The finish will be shortening eventually, if you use it. Rancid is half-oxidized. Don't store where access to air is limited, and you should be just fine.
If you can't stand it bare, shellac or lacquer.
Better to follow the leader than the pack. Less to step in.
Posts: 14,954
Threads: 0
Joined: Sep 2004
Location: Butler, PA
I think shellac would be fine. A rolling pin isn't going to be subjected to the same kind of abuse that a cutting board gets, so even though film finishes are generally not recommended for kitchen ware, shellac should be fine in your application. It's also easily renewed and repaired, so that's a plus.
If you are going down a river at 2 mph and your canoe loses a wheel, how much pancake mix would you need to shingle your roof?
Posts: 8,963
Threads: 0
Joined: Sep 2010
You can prevent olive oil from going rancid by adding 5 drops of tea tree oil per L. However olive oil doesn't dry like BLO it just becomes sticky. You can use MO&paraffin, shellac or just leave it.
homo homini lupus
"The best lack all conviction, while the worst are full of passionate intensity." Yeats
Si vis pacem, para bellum
Quodcumque potest manus tua facere instaner opere Ecclesiastes