Dividers, Calipers and Chisels

[johndi]

Assorted calipers and dividers.
Would like $40.00 for all plus shipping.
Paypal F & F preferred.

Left to Right
Union dividers
Union large calipers
small unmarked calipers
B & S dividers marked "800"
Starrett inside calipers
Anthol Machine Co. calipers



Chisels
No beauty queens, but should make good users. All need to be sharpened.
Note the 1/2 inch Everlast looks like it is developing a crack on the socket.
Would like $60.00 plus shipping for all.
Left to Right
NOS Great Neck 1/4 inch chisel
Stanley no. 60 1/2 inch with a hole drilled in handle
Everlast 1/2 inch
Everlast 1"
Everlast 3/4 "
Stanley no.40 1"
Stanley no. 40 1/2"
NOS Great Neck 2"

[johndi]

I received a PM for calipers, but you have PM's disabled so I cannot reply.

[glennw]

If his request for them falls through I can I get them.

[johndi]

Glennw, if I don't hear anything in the next few days, I will PM you.

Not sure how they were able to send me a PM but can't get them?

[iclark]

Glennw, if I don't hear anything in the next few days, I will PM you.

Not sure how they were able to send me a PM but can't get them?

When WN switched to the new software. receiving PM's was turned off by default. This is the opposite of the old software.

Anyone can send a PM, but they can not receive them until they go into the UserCP and turn on receipt of PM's.

There was a thread from Arlin with very specific instructions of how to turn on receiving PM's.

So far, the admin in the attic seem to consider this PM setting to be a feature rather than an error.

[glennw]

praying I can for my luck

[johndi]

Glennw, tried to PM you.

You also have settings set not to receive PM's.

[johndi]

Both still available.

How about $40.00 for chisels to move them along.

[glennw]

if the calipers are still available I would like to get them. you can email me at gwiederman@icloud.com I am not sure how to set pm's so I can get them.

[johndi]

Consider calipers sold.

Glenn, I will email you today.