#10
Veritas wooden beading tool. Only one cutter.

$20 plus shipping

[Image: 20170225_180841-L.jpg]
[Image: 20170225_180855-L.jpg]
[Image: 20170225_180908-L.jpg]

Veritas grinder tool rest. Excellent condition with some paint splatter.

$28 plus shipping

[Image: 20170228_172233-L.jpg]
[Image: 20170228_172247-L.jpg]

Holman Clamp Co. (Jorgenson) 18" veneer press clamps. Set of 8. I don't think you can buy these new anymore. Some paint loss, one has a patch of pitting 2" down from the handle.

$120 plus shipping

[Image: 20170228_172824-L.jpg]
[Image: 20170228_172846-L.jpg][Image: 20170228_172901-L.jpg]
[Image: 20170228_172933-L.jpg]
Reply

#11
Steve

Just wondering if those clamps can be made to used as a bench vise?   They sure look like they could and racking would no longer be a problem either.
As of this time I am now teaching vets again.  If you have any lumber scraps we can use them to glue up to make some bowl from a board which we have not done yet..  Thank You Everyone.

It is always the right time, to do the right thing.
Reply
#12
Sending you a private message on the tool rest.
Reply
#13
(02-28-2017, 09:07 PM)Arlin Eastman Wrote: Steve

Just wondering if those clamps can be made to used as a bench vise?   They sure look like they could and racking would no longer be a problem either.

I suspect they could be used it a vise setup. I'm not sure if it would be better than a normal twin screw situation though.
Reply
#14
PM sent for the veneer press clamps.

John
Reply
#15
The Veritas grinder jig and all the veneer clamps are sold, just the Veritas wooden beader remains. A set of six cutters for the beader only cost $18.
Reply
#16
The Veritas wooden beader is sold.

Let's add something else:

Benchmate 21" by 36" woodworking mat. Brand new.

$9 plus shipping

[Image: 20170302_181018-L.jpg]
Reply
FS: Veritas tools, veneer press clamps


Forum Jump:


Users browsing this thread: 1 Guest(s)