Rolling Table with Rackmount HW

[Gary™]

I need to build a table-like rolling unit for a new sound board for my church. It needs the capability to install a few rack mount units under it.

Does anybody have a good source for the rack mount hardware?

Or references to designs for units like this?

[Gary G™]

PC Connection might have what you need.
Darryl Masterson is one of their reps.
Great guy; woodworker, and segmenting woodturner.

[EricU]

I drilled my own rack mount rails.  Not much else is really needed.  Made it from 3/16" aluminum angle.  Tapped the holes with a 10-32 tap held in a hand drill.  You can buy just the rails and hardware from music suppliers. I used to get a lot of rack mount stuff from surplus dealers, but I haven't been doing that in a long time, so don't know the current state of supply.