▼ 
07-22-2018, 08:35 PM
(This post was last modified: 07-22-2018, 08:47 PM by woodcutter100.
Edit Reason: Correct spelling
)
Need some guidance please. The center bolt (pivot) on my miter gauge for the table saw fell out. I cant find a picture to give me any reference as to how to replace it. any suggestions?
▼ 
07-22-2018, 09:48 PM
Brand? Has it got a name on it? Brand of saw?
Steve
Mo. I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24 The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints WaterlooMark 02/9/2020
07-23-2018, 02:02 PM
No animals were injured or killed in the production of this post.
07-23-2018, 02:17 PM
So you have the screw but need to know how to install it?
Is this a trick question?
07-23-2018, 04:52 PM
I apologize gentlemen I thought I put Delta in the header but alas not. I don't have the screw, it was lost in the sawdust. I found one at ereplacementparts and it has threads on one end but I can't see any threads in the miter gauge or the guide bar.
As far as I can tell it is part number 185 in the schematic but as usual it is not very clear. any thoughts will help at this point Thanks ▼
07-23-2018, 06:33 PM
(07-23-2018, 04:52 PM)woodcutter100 Wrote: I apologize gentlemen I thought I put Delta in the header but alas not. I don't have the screw, it was lost in the sawdust. I found one at ereplacementparts and it has threads on one end but I can't see any threads in the miter gauge or the guide bar. I just took my Delta gauge apart to clean and tune it. The pivot bolt was difficult to remove until I realized there was a set screw too! It is a shoulder bolt, with a much smaller diameter threaded section than the size of the shoulder. On mine, the bolt actually threaded into the protractor part. ▼
07-23-2018, 09:28 PM
(07-23-2018, 06:33 PM)handi Wrote: I just took my Delta gauge apart to clean and tune it. The pivot bolt was difficult to remove until I realized there was a set screw too!Thanks Ralph that helps a great deal.......... 
07-23-2018, 05:54 PM
don't use your miter gauge . You asked ....... I have never used mine . On my sliding table yes . On saw no . Find out what thread it is . 97% of the battle.
If it can't kill you it probably ain't no good. Better living through chemicals.
07-23-2018, 10:10 PM
Take a large magnet in your hand and pass it back and forth in the saw dust to locate the missing screw.
▼ 
07-25-2018, 07:50 PM
(07-23-2018, 10:10 PM)RogerD Wrote: Take a large magnet in your hand and pass it back and forth in the saw dust to locate the missing screw. What he said. I keep a magnet on a stick handy for just such situations. Frequently the arbor nut to my TS 
"Truth is a highway leading to freedom" --Kris Kristofferson
Wild Turkey We may see the writing on the wall, but all we do is criticize the handwriting. (joined 10/1999) |
|
MIter gauge pivot bolt missing
|
|
|
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
