Looking for 1/16" bandsaw blade.

[Chuck Nickerson]

Any leads for me?

[woodhead]

Any leads for me?

Olsen makes a few, but most companies start at 1/8"








Al

[Mr Eddie]

Olsen makes a few, but most companies start at 1/8"








Al

What width?

Lonnie

[bandsaw]

I have one - got it at Highland Hardware

Guy used to demonstrate boxes and log castles on youtube - said he used a 1/16 inch blade

It's a little bigger than 1/16 not counting teeth

[bandsaw]

I happened to be in Atlanta so picked one up

Then went home and bought a bigger bandsaw

Never used it

[Alan S]

A decade or two ago, after reading Duginske's bandsaw book, I looked for a 1/16" blade. At that time there were still references to which company had made them (Starrett? Lenox?) but they had been discontinued and were no longer for sale.

[bandsaw]

I still have the 1/16th blade - never used - sized for Delta 14" saw

I recently moved my shop and it's in a box somewhere - I can find it

I can mail it - I'm in Canada

[Arlin Eastman]

Glad you made the post.  I was looking for one so we could use it for bandsaw boxes.

[Alan S]

Glad you made the post.  I was looking for one so we could use it for bandsaw boxes.

I would have thought a 1/8" blade would be sufficient for bandsaw boxes, even with quite tight curves.  The 1/16" blade is of particular use for fitting sideways into a tablesaw kerf, for instance to cut dovetail baselines in one pass.

[Arlin Eastman]

I would have thought a 1/8" blade would be sufficient for bandsaw boxes, even with quite tight curves.  The 1/16" blade is of particular use for fitting sideways into a tablesaw kerf, for instance to cut dovetail baselines in one pass.

For that to. Well hopefully.