Posts: 4,920
Threads: 0
Joined: May 2010
Posts: 4,021
Threads: 0
Joined: Nov 2010
Soooo....just exactly HOW would you go about sharpening this?
Show me a picture, I'll build a project from that
Posts: 5,209
Threads: 0
Joined: Jan 2014
Location: Santa Maria, Ca
I think I would try to chuck it into a power drill and run in reverse on sandpaper, holding it at the right angle of course.
Easier said than done of course. If you have a spare auger chuck, perhaps an adapter of some kind could be made.
Mark Singleton
Bene vivendo est optimum vindictae
The Laws of Physics do not care about your Politics - Me
Posts: 598
Threads: 0
Joined: Mar 2007
Location: NW of Fort Worth, TX
If you remove the screw can you fit sandpaper glued to a piece of sheet metal between the two halves?
Posts: 4,021
Threads: 0
Joined: Nov 2010
Yep, and..the 2 halves can rotate side to side, as there is a pivot point up at the tapered end.
Show me a picture, I'll build a project from that
