08-16-2019, 09:02 PM
Finally got the blade guide bearings adjusted, maybe even correctly, and moved to table alignment. Loosen all the trunnion bolts - table won't align. Called Grizzly Tech Support - and they said to loosen the trunnion mounting bolts. Which I did after a battle getting the allen wrench into tight quarters. Got the table lined up perfectly, and got 1 bolt snug. Then, you guessed it, stood up and knocked the table out of alignment. Another battle with the bolts and got it aligned again - not as well as the first time but I'm calling it good. At this point, I had spent 3+ hours in triple digit heat getting frustrated. Tomorrow is another day.
Thanks, Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard