Woodnet Forums › › Active › Woodworking v
Advice needed on legs--Updated with pics--
Thread Modes
Advice needed on legs--Updated with pics--
Tapper Offline
Honored Veteran
Posts: 16,600
Threads: 2
Joined: Oct 1999
#25
12-31-2018, 01:05 AM
Ya done good!

Doug
Find
Reply
camp10 Offline
Member
Posts: 7,227
Threads: 1
Joined: Mar 2004
Location: Western Colorado
#26
12-31-2018, 08:18 AM
Good looking table.

How did you get that bevel on the top piece? Especially on the end grain sides.
Find
Reply
shoottmx Offline
Huey gunship door gunner-'68
Posts: 1,617
Threads: 0
Joined: Feb 2010
Location: Coast of Maine
#27
12-31-2018, 01:54 PM
(12-31-2018, 08:18 AM)camp10 Wrote: Good looking table.  

How did you get that bevel on the top piece?  Especially on the end grain sides.

Thanks everyone. The bevels were cut on the table saw with the blade angled about 20*. I made an auxillary fence about 18" high out of MDF and bolted it to the face of my Incra TSLS. I added feather boards both infeed and outfeed. I was careful to feed at an even rate but cutting the bevels was quick and easy.

g
I've only had one...in dog beers.

"You can see the stars and still not see the light"
The Eagles: Already Gone
Website Find
Reply
Hank Knight Offline
Member
Posts: 925
Threads: 0
Joined: Jan 2013
Location: Columbia, SC
#28
01-01-2019, 10:06 AM
That turned out nice! I like it a lot better than your earlier pic. Your wife has a good eye.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.