Woodnet Forums › › Active › Tool Swap N' Sell v
HTC Outfeed Roller table
Thread Modes
HTC Outfeed Roller table
Jack01 Offline
Member
Posts: 1,741
Threads: 0
Joined: Jul 2003
Location: Denver,CO
#14
12-30-2016, 09:58 PM
(12-30-2016, 05:19 PM)Farmerdave Wrote: Will this fit a powermatic 66 with  Biesemeyer fence?
Thanks,Dave

Dave
I tried to send a PM , but could not access your PM
Please send me your e mail address to my PM so I can send the manual.
Find
Reply
joemac Offline
Member
Posts: 5,122
Threads: 0
Joined: Nov 2003
Location: Shitcago
#15
01-01-2017, 02:46 PM
I have this on my SawStop and have used it for almost ten years without a hitch.  One of the few products that works better than advertised
"We sleep soundly in our beds because rough men stand ready in the night to visit violence on those who would do us harm"
                                                                                                                        Winston Churchill
Find
Reply
Farmerdave Offline
Member
Posts: 57
Threads: 0
Joined: Jul 2005
#16
01-01-2017, 03:30 PM
Jack,
I believe I have the PM enabled now.
Thanks,
Dave
Find
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.