|
Whiteside tongue and groove set.
|
 (09-20-2017, 08:03 AM)JGrout Wrote: Not sure what set you are looking at but there is a shaker set that has a slight 5 degree angle in the groove cuts I am looking at the Whiteside site and I'm not seeing that: https://www.whitesiderouterbits.com/products/5990
No animals were injured or killed in the production of this post.
09-20-2017, 08:45 AM
(09-20-2017, 08:19 AM)Cooler Wrote: I am looking at the Whiteside site and I'm not seeing that: I think it might be that the T&G assembly shows as a single bit you can rearrange for the two cuts and the shaker set is two bits Seems silly to me but that is all I can conclude Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future John F. Kennedy
09-20-2017, 06:13 PM
(09-20-2017, 08:45 AM)JGrout Wrote: I think it might be that the T&G assembly shows as a single bit you can rearrange for the two cuts and the shaker set is two bits Bingo
Steve
Mo. I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24 The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints WaterlooMark 02/9/2020  (09-20-2017, 08:03 AM)JGrout Wrote: Not sure what set you are looking at but there is a shaker set that has a slight 5 degree angle in the groove cuts That post you made showing this T&G cutter. Look at the lower pic, and squint if you need to, but the carbide sits at a 5* angle to the plate. At least on mine it does. It's very subtle, and on the cut you'll never notice it, but it probably goes along the same thought as putting stock into a planer at a slight angle so to make a shearing cut (more efficient), as opposed to a flat cut (more heat, less efficient) I think that may be what Joe was referring to. I'm not positive, but that 5* occurs on a lot of their slot type cutters. Plus the Shaker is 2 bits, as opposed to a single adjustable one, I'd bet that is the price difference.
Worst thing they can do is cook ya and eat ya
 GW
09-24-2017, 07:25 PM
Whiteside has the 5990 shaker set but they do not have a bevel. You can always run an edge bevel bit if you want that effect, no 5 degree but there is a 7 degree. Whiteside does the have 5980 raised panel bit that has a 15 degree bevel on it.
|
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
