Woodnet Forums › › Active › Tool Swap N' Sell v
SOLD 5/8" Jacobs chuck + arbor + key
Thread Modes
SOLD 5/8" Jacobs chuck + arbor + key
Aram Offline
Member
Posts: 4,814
Threads: 1
Joined: Jan 2004
Location: Eugene, OR
#4
06-17-2019, 06:03 PM (This post was last modified: 06-19-2019, 09:15 AM by Aram.)
I bought this off of eBay, then realized it is 5/8", instead of the 1/2" version I wanted. Someone give this a good home.

Jacobs chuck, used but in very good shape. It turns easily by hand but is not at all loose. I chucked up a 1/2" gauge pin, put a travel gauge on it, and spun it by hand. 0.001" total runout. Crazy, just dead nuts.

I'm including the MT2 JT3 arbor I bought from Amazon. 

SOLD

[Image: i-vn2sQjG-M.jpg]
[Image: i-MhMqWKv-M.jpg]
[Image: i-KDW8tqG-M.jpg]
Best,
Aram, always learning

"Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away.” Antoine de Saint-Exupery

Web: My woodworking photo site
Find
Reply
Timberwolf Offline
Honored Veteran
Posts: 116,077
Threads: 0
Joined: Jun 2002
Location: Sparkling Clearwater, Fl. Tampa Bay Area
#5
06-17-2019, 06:45 PM
(06-17-2019, 06:03 PM)Aram Wrote: I bought this off of eBay, then realized it is 5/8", instead of the 1/2" version I wanted. Someone give this a good home.

Jacobs chuck, used but in very good shape. It turns easily by hand but is not at all loose. I chucked up a 1/2" gauge pin, put a travel gauge on it, and spun it by hand. 0.001" total runout. Crazy, just dead nuts.

I'm including the MT2 JT3 arbor I bought from Amazon. 

This cost my $163 off of eBay. Yours for $130 including shipping, CONUS only.

[Image: i-vn2sQjG-M.jpg]
[Image: i-MhMqWKv-M.jpg]
[Image: i-KDW8tqG-M.jpg]
..............
I didn't check to see but I believe that is the ball-bearing super chuck...and it is aptly named IMO....One of the best they make!!!!
Often Tested.    Always Faithful.      Brothers Forever

Jack Edgar, Sgt. U.S. Marines, Korea, America's Forgotten War
Get off my lawn !
Upset





Find
Reply
sniper Offline
Pirate from way back
Posts: 22,408
Threads: 0
Joined: Dec 2004
Location: Monrovia, AL
#6
06-17-2019, 08:07 PM (This post was last modified: 06-17-2019, 08:10 PM by sniper.)
JT3 not a JT33 correct? I need a new chuck for my drillpress but it's a 33. I'll take it if it's a 33.

Never mind, just looked a little closer at your last pic. Oh well.
Find
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.