I’m not sure about this saw that I have. I've uploaded three images. There are no company names, logos, or markings of any kind. The handle looks to be oak. The overall length is about 22 inches, the blade is about 18 inches. The interesting thing is that the blade tapers down several inches from the end approximately 1/4 inch, at which point there is a little spike protruding from the blade that is about 1/8 inch tall. Can anyone tell me what this is for or exactly what might be the unique purpose of this saw?
You have done it now. You have asked the purpose of the nib- the start of many a fight on hand tool forums. Some will tell you it is like a gun site, others will claim it is used to notch the start of the cut. Those people are totally wrong. It is simply a vestigial remnant of a decorative element used on saws from antiquity.
As for the saw I can't tell if the handle is large enough for an adult. It looks too small and crudely made. So possibly a child's saw. If meant for an adult, it looks like a table saw. The narrow width allows a person to saw out round table tops.
(09-15-2019, 05:53 PM)WJB Wrote: You have done it now. You have asked the purpose of the nib- the start of many a fight on hand tool forums. Some will tell you it is like a gun site, others will claim it is used to notch the start of the cut. Those people are totally wrong. It is simply a vestigial remnant of a decorative element used on saws from antiquity.
As for the saw I can't tell if the handle is large enough for an adult. It looks too small and crudely made. So possibly a child's saw. If meant for an adult, it looks like a table saw. The narrow width allows a person to saw out round table tops.
Sorry...I wasn’t trying to open Pandora’s box, but many thanks for your reply.
I think you have a very old panel saw that's been sharpened many times. I also think the handle has been replaced. Disston added the nib (spike as you refer to it), and nobody really knows the purpose. Perhaps just decorative. Is there a medallion on the other side of the handle where the screws are? If so, take a pic of that and post it. That would help in ID. Otherwise, I think you have a generic hardware store saw. Disston's handles on their panel saws were attached with more screws than just the two on your saw.
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
