Posts: 164
Threads: 0
Joined: Feb 2019
So I just replaced my hot water heater and the female threaded fitting going onto the dielectric nipple coming out of the water heater will not seal up. I first reused the old one then when that leaked I got a new one. Our code requires hard pipe so no easy flex trials so each time I want to change something I have to cut the pipe again. On another water project earlier this year I had the same problem with a threaded connection. I ended up getting some T plus 2 pipe dope and that finally sealed it up. Is there any reason I can't use this on the water coming out of the water heater? I am also thinking I will get a slip union to put in this pipe just incase this takes some more trials.
Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
Either dope or tape, I use what is handy. Usually tape as I have a big supply.
I wouldn't think twice about putting a union on those pipes.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 18,586
Threads: 0
Joined: Jul 2006
Location: Milwaukee area
Sure you can use T Plus 2, that is exactly what I'd be doing. Tape doesn't work great on new threads unless both sides were cut by the same vendor, IMHO.
Posts: 2,274
Threads: 90
Joined: Jun 2001
I have never replaced a WH without having to redo the hot water side. I put pipe dope on them all the time and I still have to redo them - only the hot water side.
John
Always use the right tool for the job.
We need to clean house.
Posts: 1,187
Threads: 0
Joined: Dec 2009
Location: Grand Rapids, Minnesota
A good friend is a well driller, all joints get 2 wraps of Teflon and pipe dope. No call backs.
Posts: 12,898
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
I have much better luck with pipe dope than tape. I put unions and shut off valves in both the hot and cold lines to the hot water heater so swapping out the old for a new one, or dealing with a leak like you have, is less of a hassle.
John
Posts: 4,920
Threads: 0
Joined: May 2010
Can you not use a union so you don't have to cut the pipe
Posts: 164
Threads: 0
Joined: Feb 2019
I can't get a break with this project. I put on the union and applied pipe dope to the threaded connection to the water heater. The threaded connection leaked so at least I was able to disconnect the union and give the threaded connection a little more twist. Now I noticed the union is weeping just a little. I am thinking of loosening the nut and wiping some pipe dope around where the two pieces come together. I hope that will finally seal this thing up.
Posts: 64,782
Threads: 3
Joined: Feb 2007
Location: Merryland
Posts: 2,716
Threads: 0
Joined: Mar 2001
Location: Los Angeles
I have had unions leak before, an ocasional drip.
My fix was to give it a few days and the leak creates enough corrosion to "heal" the leak. This is only a once in a while sort of thing. Not very professional but when ample tape and tightening doesn't seem to work it went away on it's own.
-------------------------
I married my wife for her looks, just not the ones she has been giving me lately
