Posts: 381
Threads: 0
Joined: Jun 2002
I have a reconditioned Ridgid 6" random orbital sander (model R2611). Worked great for years. Suddenly started shuddering and doesn't reach full power. No obvious damage. Any ideas?
Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
Check the shaft bearing where the pad bolts on. May be kapute.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 381
Threads: 0
Joined: Jun 2002
Finally got to take the sander apart. The shift and bearings look OK. I'm stumped.
Posts: 262
Threads: 0
Joined: Jan 2020
That sander has an LSA. I'm not sure now that you've taken it apart. In my experience with smaller tools, if you registered it properly they will just give you a new one. Even on my spindle/belt sander, when it developed a shudder, they kept the housing and shoved a new sander under it as the repair.
When I was young I sought the wisdom of the ages. Now it seems I've found the wiz-dumb of the age-ed.
Posts: 770
Threads: 0
Joined: Jan 2007
Location: ATL
bypass the speed controller and see if that's the problem.
