Posts: 482
Threads: 0
Joined: Apr 2011
I was looking at adding a smaller sprayer to my fuji mini mite 4 turbine. I see fuji makes a touch up gun but wanted to know if there were other recommendations or has any one tried the fuji. I need the sprayer to work with a turbine not a compressor setup. Thank you.
Posts: 7,421
Threads: 1
Joined: Sep 2005
Paasche makes an airbrush for HVLP sprayers. I have not used it though. Paasche is probably the biggest name in the airbrush industry.
The only small parts I spray are screw heads. For that I get a sheet of corrugated cardboard and I poke holes in the cardboard and screw the screws into the sheet of cardboard leaving about 1/8" space between the head and the cardboard.
Then I spray the sheet and all the heads get painted at one time. I leave them in the cardboard until I am ready to drive the screws in.
No animals were injured or killed in the production of this post.
Posts: 482
Threads: 0
Joined: Apr 2011
Thank you for the reply. I will have to check them out. I don't need to spray anything that small lol. I am looking to spray 3D printed parts.
