Metal roof on lean-to shed

[atgcpaul]

I'm almost ready to put on the screw down metal roof panels on my lean-to shed, but I can't seem to find information on what to do at the peak (is it called the peak or maybe ridge?). What kind of metal trim do I use there that covers the peak and hangs down over the fascia? Do I use the same trim as on the gable ends which lays flat to the fascia, or the same drip edge flashing that has a kick out? Or is there a more appropriate trim to use?

Thanks
Paul

[cams2705]

I'm almost ready to put on the screw down metal roof panels on my lean-to shed, but I can't seem to find information on what to do at the peak (is it called the peak or maybe ridge?).  What kind of metal trim do I use there that covers the peak and hangs down over the fascia?  Do I use the same trim as on the gable ends which lays flat to the fascia, or the same drip edge flashing that has a kick out?  Or is there a more appropriate trim to use?

Thanks
Paul

Below is a link to a page for a local supplier near me that shows a picture representation of all the parts of agricultural trim and accessories.  I'm sure there is a supplier near you with something similar.

https://martinsmetalroofing.com/wp-conte...-Sheet.pdf

[EatenByLimestone]

Rake trim goes over the fascia, drip edge along the bottom, and ridge cap on the ridge. In order to get everything to look right, I had to bend a bottom panel for tge fascia, and then modify the rake, but you may not have to. It all depends on the look you're after and the length of your brake.