08-18-2024, 12:17 PM
Rehabbed a Brace Drill this morning..that I "picked" for $3...
Stanley No. 945-10in. decided to give it a test drive...chucked a #12 bit into the now working chuck..
Ratchet was frozen..drill was a mess, actually..
And the rest of Friday's pickings...
So, what does all this have to do with the Project at hand?
I needed to drill 6 holes, 3/8" or so deep...with that 3/4" bit...to house the 3 rods for the fold down towel rack..
Which is now sitting in the clamps while the glue sets up..
Had to cut the rods down about 2"....and make sure they were all even.
Need to work on hanging the 2 doors next time in the shop...and add a Top Shelf...and decide on a finish other than paint...
Stay tuned..
Stanley No. 945-10in. decided to give it a test drive...chucked a #12 bit into the now working chuck..
Ratchet was frozen..drill was a mess, actually..
And the rest of Friday's pickings...
So, what does all this have to do with the Project at hand?
I needed to drill 6 holes, 3/8" or so deep...with that 3/4" bit...to house the 3 rods for the fold down towel rack..
Which is now sitting in the clamps while the glue sets up..
Had to cut the rods down about 2"....and make sure they were all even.
Need to work on hanging the 2 doors next time in the shop...and add a Top Shelf...and decide on a finish other than paint...
Stay tuned..
Show me a picture, I'll build a project from that