Posts: 3,057
Threads: 0
Joined: Dec 2006
Location: Concord, NC
Got a new Dewalt Jobsite saw with the stand and the miter gauge is garbage. I was thinking of adding an Incra. The guide bar is steel. Am I over thinking the effects of sliding steel over an aluminum too and miter slots?
"Life is too short for bad tools.".-- Pedder 7/22/11
Posts: 12,046
Threads: 1,611
Joined: Jan 2001
Location: Kansas City, Kansas
I have a Rigid TS2424 and use an Incra V-27 ---going on 14 years..
I also have a Porter Cable portable job site saw with an all aluminum top and use an Incra V-27---going on 13 years.
No slop at all---have never readjusted the slide width on either miter gauge.
Posts: 3,057
Threads: 0
Joined: Dec 2006
Location: Concord, NC
Thank you
"Life is too short for bad tools.".-- Pedder 7/22/11
Posts: 9,536
Threads: 0
Joined: Jan 2005
Location: Orlando FL
My Incra V27 has a pad on the bottom of the gauge part and only one side of the bar makes contact with the saw. The other side has some of those low friction plastic washers that compress to take up slop in the groove.
Posts: 3,057
Threads: 0
Joined: Dec 2006
Location: Concord, NC
Thanks a lot for the replies. Looks like I'll get one.
"Life is too short for bad tools.".-- Pedder 7/22/11
Posts: 22,710
Threads: 0
Joined: Feb 2005
Location: Regina Saskatchewan Canada
Find a bit of wax for the bar and slot whilst shopping.
Blackhat
Bad experiences come from poor decisions. So do good stories.
