looking for source 1/2" Barrel nut ( Dowel nut)

[Jack01]

I am looking for source 1/2" Barrel nut ( Dowel nut)
So far I have not located yet. 
I only need 4 nuts.

Once source I found the minimum order was 144 nuts.
Any suggestions.

I am looking for cross dowels for 1/2 screw.

[budglo]

Ace Hardware has them. Any size you want .

[DaveR1]

I am looking for source 1/2" Barrel nut ( Dowel nut)
So far I have not located yet. 
I only need 4 nuts.

Once source I found the minimum order was 144 nuts.
Any suggestions.

Are you looking for cross dowels for 1/2 screws or 1/2 in. diameter cross dowels or 1/2 in. long?

[Jack01]

Ace Hardware has them. Any size you want .

Ace Hardware do not carry 1/2 threaded barrel nuts, already checked that source

[Jack01]

Are you looking for cross dowels for 1/2 screws or 1/2 in. diameter cross dowels or 1/2 in. long?

I am looking for cross dowels for 1/2 screw.

[jasfrank]

If you had a drill press and a 1/2" tap that sure wouldn't be a difficult thing to make 4 of those.

[Phil Thien]

Lee Valley has these:

http://www.leevalley.com/en/wood/page.as...55&p=67659

...although the cross dowels themselves look a little short.

Rockler has these:

https://www.rockler.com/heavy-duty-cross...olt-8-pack

...although they're 1/2-12?

Woodcraft has these:

https://www.woodcraft.com/products/highp...lt-4-piece

...although they state 1/2" w/o TPI, so I don't know if they're -13 (which is typical, right?).

[Aram]

How about these?

Benchcrafted

[Phil Thien]

FWIW, I wanted something similar when I built my workbench base from LVL and found a 1/2" wing nut worked the trick.  I'll confess it isn't as fancy, but it sure was less expensive and readily available.  It has been 15-ish years and the bench is solid as a rock.

I just held onto one of the wings until the threads were started, didn't take any more effort than conventional cross dowels.

[Jack01]

How about these?

Benchcrafted

Thanks  Benchcraft will work. I just needed the barrel nuts, but I will get the set from Benchcraft.