diamond cone for hollow chisel mortiser
#8
Hey Folks, I've been looking for a sharpening cone for a 5/8 mortising bit. I got some off ebay that are too small for this larger size chisel. I was watching a Bob Van Dyke video on FWW and he had a set of huge cones that would sharpen any size mortiser bit but I cannot find them at all. Does anyone know where to find these huge cones? Here's the link to the video. https://www.finewoodworking.com/2014/06/...=645076275
How do you know you're learning anything if you don't screw up once in awhile?

My blog: http://birdsandboards.blogspot.com/
Reply
#9
Seems Grizzly had some. Might ck there.
Steve

Missouri






 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply
#10
(12-16-2019, 03:12 PM)mr_skittle Wrote: Hey Folks, I've been looking for a sharpening cone for a 5/8 mortising bit. I got some off ebay that are too small for this larger size chisel. I was watching a Bob Van Dyke video on FWW and he had a set of huge cones that would sharpen any size mortiser bit but I cannot find them at all. Does anyone know where to find these huge cones? Here's the link to the video. https://www.finewoodworking.com/2014/06/...=645076275


I may have still new ones I've never used.  I'll check tonight....
"This is our chance, this our lives, this is our planet we're standing on. Use your choice, use your voice, you can save our tomorrows now." - eV
Reply
#11
I believe Lee Valley sells them.
Waiting to grow up beyond being just a member
www.metaltech-pm.com
Reply
#12
(12-16-2019, 03:12 PM)mr_skittle Wrote: Hey Folks, I've been looking for a sharpening cone for a 5/8 mortising bit. I got some off ebay that are too small for this larger size chisel. I was watching a Bob Van Dyke video on FWW and he had a set of huge cones that would sharpen any size mortiser bit but I cannot find them at all. Does anyone know where to find these huge cones? Here's the link to the video. https://www.finewoodworking.com/2014/06/...=645076275

I've cut hundreds upon hundreds of mortises over the years, mostly in mesquite and cherry.  I use 400g on a flat surface and hit the outsides.  Never touched the inside.   For whatever that's worth...
Reply
#13
You really do not need one large enough to just plunge in. A diamond stone needs to move around as it is used or it will stop removing material and just create heat after that. it is much better to gently move the stone in and out of the chisel while also slowly going around the bore.
Proud maker of large quantities of sawdust......oh, and the occasional project!
Reply
#14
I got mine at Woodcraft.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.