I broke the small push red button on my jointer. The whole thing still works, in fact I can even sometimes sort of get the plastic knob to go back in and turn the unit off.
Any ideas on how to replace just that? Everything I find on grizzly wants to replace the entire assembly, which is almost $30! Was hoping to somehow just but the plastic piece, or figure out a way to fix it?
Can you just put a piece of dowel into the hollow center of the white tube and line it up? Personally I'd be inclined to replace the whole switch, this is just one of those things.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
If you like the dowel idea but are concerned with the light.... can you find some pvc pipe or other tubing that would work? If a little smaller, some tape on the outside of the tube could solve diameter deltas
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
