Woodnet Forums

With shaper moved 16' in and out. Shaper is there till cnc moves under mezzanine but it is mobile. Same will be for planer and jointer and drum sander opposite direction 16' in and out.

(06-17-2018, 10:57 PM)BloomingtonMike Wrote: [ -> ]With shaper moved 16' in and out. Shaper is there till cnc moves under mezzanine but it is mobile.  Same will be for planer and jointer and drum sander opposite direction 16' in and out.

 
I set up for 12' as that was the length of material I used to order. And my lumber rack is set up for 12'.

Got a few bessey parallels hung up in the new shed. Found a higher density clamp rack I liked and cut the triangles and sides out on cnc. Actually building a couple racks.

(08-17-2018, 03:00 PM)BloomingtonMike Wrote: [ -> ]Got a few bessey parallels hung up in the new shed. Found a higher density clamp rack I liked and cut the triangles and sides out on cnc. Actually building a couple racks.

how many does that hold?  I have over 100

Looks like 36...........

https://gumroad.com/l/parallelclamprack

That is where i got the parallel clamp design.

It holds 36. I just counted and i think i have about 50 more to hang too so I am right there with you. I am going to start assembling the second tonight. I actually cut a 3rd set of odd shaped parts out on the cnc so with a few straight table saw cuts ill have a 3rd ready to paint. Ill config it for some long dubuke clamps too and 6 bowclamps maybe. My f clamps use a different rack.

(08-17-2018, 08:28 PM)BloomingtonMike Wrote: [ -> ]https://gumroad.com/l/parallelclamprack

That is where i got the parallel clamp design.

It holds 36. I just counted and i think i have about 50 more to hang too so I am right there with you. I am going to start assembling the second tonight. I actually cut a 3rd set of odd shaped parts out on the cnc so with a few straight table saw cuts ill have a 3rd ready to paint. Ill config it for some long dubuke clamps too and 6 bowclamps maybe. My f clamps use a different rack.

Sounds like you could have a new product line

If you are in the area bob come by and ill cut some for you

I was up late into the AM and assembled the second and made and painted parts for two more. One will be about 1/2 as wide.

(08-19-2018, 06:53 AM)BloomingtonMike Wrote: [ -> ]If you are in the area bob come by and ill cut some for you

I was up late into the AM and assembled the second and made and painted parts for two more. One will be about 1/2 as wide.

Thanks for the offer but I was serious. I bet if you cut those out and packed in flat boxes they would sell.  No need to make more than one or 2 to check the water and it is probably safe bet if they don't sell you will eventually put them to use.

Added F clamps/bessey tradesman clamps on another style clamp holder I drew up. Turns out the space between the parallels was just enough for these. The new racks also have room to store several clamps to drive up clamp density.