Posts: 21,850
Threads: 0
Joined: Oct 2003
11-01-2018, 07:36 PM
(This post was last modified: 11-01-2018, 07:37 PM by Gary G™.)
Glue a 1” X 1” hardwood beam under or to the front of the plywood shelf and stop worrying about sag.
Gary
Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.
Posts: 7,421
Threads: 1
Joined: Sep 2005
It is going to be open shelving which you can see through to the sun room. I was hoping to keep the shelves to 3/4". I would go with 1/2" thick glass shelves but at nearly $200.00 per shelf that is off the table.
No animals were injured or killed in the production of this post.
Posts: 954
Threads: 0
Joined: Feb 2005
Location: San Diego, CA
(11-02-2018, 08:01 AM)Cooler Wrote: It is going to be open shelving which you can see through to the sun room. I was hoping to keep the shelves to 3/4". I would go with 1/2" thick glass shelves but at nearly $200.00 per shelf that is off the table.
You can address the sag with a piece of 1/2" aluminum angle screwed to the back of the shelf. That will add a lot of streght w/out making the shelf thicker. If you want to go "fancy" you can rout a recess so it is flush.
-Brian
Posts: 5,653
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
I believe they are really strong, even in the worst particle board. The main problem I can see is when there is a lot of clearance. I suspect that 25 pounds is conservative.
Posts: 2,274
Threads: 90
Joined: Jun 2001
If you don't want to see a wide shelf then put the edge on the back; you'll not see them easily. I have also put a 1" board running down the middle on lower shelves.
John
Always use the right tool for the job.
We need to clean house.
Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
I believe he wants open shelves, seen on both sides.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
